MGB - Wire Wheel Conversion Kit (1962-1967 - Banjo Axle)
This kit converts steel wheel MGB's with Banjo Axles to accept splined wire wheels. These are integral hubs, similar to cars that left the factory with wire wheels.
This is also the kit you need if your old splined hubs are worn and need replacing (see picture). A worn spline can be VERY dangerous and allow your wheel to separate from the car.
3 Kits to Choose from:
#1 - 1962 to early 1964 with Banjo Axle and 12tpi Spinners
(4) 42mm Splined Hubs - 12tpi
(4) 2-ear "Knockoff" spinners (2 left / 2 right) - 12tpi
#2 - Early 1964 to 1967 with Banjo Axle and 8tpi Spinners
(4) 42mm Splined Hubs - 8tpi
(4) 2-ear "Knockoff" spinners (2 left / 2 right) - 8tpi
#3 - Early 1964 to 1967 with BOLT ON Rear Hubs for Banjo Axle and 8tpi Spinners
(2) 42mm Integral Splined Front Hubs - 8tpi
(2) 42mm Bolt-On Splined Rear Hubs - 8tpi
(4) 2-ear "Knockoff" spinners (2 left / 2 right) - 8tpi
(8) Mounting Nuts (for the rear hubs)
NOTE: Unless fitted as original equipment, the rear bolt-on hubs will increase the track by approximately 1.25" per wheel.
(Product Source: England)
